Skype Me™!
:
Product Details
FASST-compatible TFR8-S receiver 2.4
  • Model: TFR8-S

FASST-compatible TFR8-S receiver 2.4

$65.00
FASST-compatible TFR8-S receiver 2.4Ghz Futaba

item#: TFR8-S
1.TF Receivers
Please note that there are many differences between other brand and FrSky, especially in the binding procedure and failsafe setting. Read the instruction manual carefully and set up devices as described below.
1.1 Compatibility:
FASST 2.4G: Air Systems (7CH Mode/Multi Mode)
& Surface Systems (C1 Mode)
FrSky TF Modules: TF-8M, TF-14M
1.2 Specifications:
Number of Channels: 8
Operating Voltage Range: 3.5V~10V
Dimension: 54*30*15mm
Weight: 14.9g
Latency: 14ms (FS)
7ms (HS)
1.3 Features:
1) Compatible with Futaba FASST 2.4GHz systems, including ground systems (such as 3PK, 4PK)
2) Parallel with TFR8/TFR8-S to become a 14 channel FASST compatible receiver
3) Improve capability of anti-interference
4) Firmware upgradable
2. Setup

2.1 Bind procedure:

Turn on the transmitter, connect the battery to the receiver while pressing receiver’s F/S button. After the RED

LED is off and GREEN LED is solid, the binding process is completed and the receiver is operating normally.

2.2 Setting failsafe:

TF series receivers support failsafe function for all channels. Follow the steps below to set failsafe:
1) Bind the receiver first, and disable failsafe on the transmitter side;
2) Set all transmitter controls to the desired failsafe position;
3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating the failsafe

is set up successfully.
If you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.

Warning: Some transmitter manufacturers use a failsafe method that can interfere with that used

by FrSky. Be sure to disable any transmitter failsafe settings before setting FrSky failsafe positions.

Unusual jitter may result otherwise.

2.3 LED status:

RED LED


GREEN LED


Mode

Off


On


Normal mode

On


On


Waiting to be bound

Flashing


On


Signal lost

On


Flashing twice


Set failsafe

Flashing slowly


On


FS mode

Flashing fast


On

HS mode
3. How to switch between two PPM modes

Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and

then release. The red LED will flash fast in HS Mode and slowly in FS Mode.Repeat this to alternate modes.

Warning: HS Mode is only applied for high-speed digital servos. Other servos should select FS Mode, otherwise servos will get heat or

even burn out.

4.Solution for Multi-channel receiver

Add to Cart:


This product was added to our catalog on Saturday 21 April, 2012.